Pro/ENGINEER Forum: Unbending a Louvre

SCUBARENE
Member

Joined: 26 April 2012
Location: South Africa
Online Status: Offline
Posts: 1

Posted: 26 April 2012 at 1:52am | IP Logged

Hi Everyone

I need help with a part,I need to bend a Louvre,but when I try to unbend it says "Geometry is not unbendable"

Part was created by sketching and extruding and then converting to Sheetmetal.

I tried adding a flat wall but with same result.

Working in Pro E 5

Any help is appreciated

Thx

-Sorry Picture added

Edited by SCUBARENE on 26 April 2012 at 2:27am